Wiring

There are 3 long wires and 1 short wire.

• The long wire with the black connector is for the Z axis motor
• The long wire with the green connector is for the X axis motor
• The long wire with the blue or orange connector is for the Y axis motor at the opposite side of the drag chain
• The short wire with the blue or orange connector is for the Y axis motor at the side of the drag chain

Connect the cables with the green and black connectors to the X axis and Z axis motors respectively:

Open the drag chain links like this (see the marking for a screwdriver – it then clicks open)

And you can already attach the drag chain for the X axis and put these two cables in:

Wait to close it until you also have attached the Z axis limit switch and until you have placed the spindle – as the cables for these will also sit in that drag chain – or you can already close it and re-open it later of course:

The the remaining long cable for the motor and attach it to the motor at the Y axis furthest away from the Y axis drag chain:

The shortest motor cable will then be plugged into the motor closest to the Y axis drag chain, and all cables can then be put together:

You can already put them in the drag chain there as well – but do not close yet until the cables for the Z axis limit switch and for the spindle are there (or you can open the drag chain later again of course):