X-gantry assembly

here, all same as workbee instructions

Attach one finished side plate to the X axis C beam and drag chain rail, with 15mm screws:

Attribution and credit: picture copied from https://www.thingiverse.com/thing:2538752/files from file “WorkBee-Screw-Assembly-Manual.pdf” as made by Ooznest and made available under Attribution-ShareAlike 3.0 Unported (CC BY-SA 3.0) license (link: https://creativecommons.org/licenses/by-sa/3.0/ )

And then: roll the X carriage on the C beam:

Before attaching the second finished side plate (and also attaching the leadscrew to the X axis motor) – note that you can also add t-nuts (marked as number 8) to later add reinforcements to the structure:

Attribution and credit: picture copied from https://www.thingiverse.com/thing:2538752/files from file “WorkBee-Screw-Assembly-Manual.pdf” as made by Ooznest and made available under Attribution-ShareAlike 3.0 Unported (CC BY-SA 3.0) license (link: https://creativecommons.org/licenses/by-sa/3.0/ )

If you want, you can also add reinforcement to the structure now – this is optional:

Attribution and credit: picture copied from https://www.thingiverse.com/thing:2538752/files from file “WorkBee-Screw-Assembly-Manual.pdf” as made by Ooznest and made available under Attribution-ShareAlike 3.0 Unported (CC BY-SA 3.0) license (link: https://creativecommons.org/licenses/by-sa/3.0/ )

SHOPPING CART

close
Translate »